.png "FDI Dental Lab Wet Model Shaping Trimmer Abrasive Diamond Disc Wheel Double Head No.: #G18000752")
Features:
1. Connect one end of the water tube to the nozzle of the wet model trimmer and the other end to the tap, open the valve
2. Connect the waste-disposal tube to the unit
3. Connect the power cord, and switch on the power switch (O=off, l=on)
4. When braking, it is normal to hear clicking before the sand tablet stops. If the sand tablet makes unusually loud noises, remove it, and use the included hex-wrench to adjust the screw on the back cover (18)
5. To check if you need to replace the abrasive disk, rotate the disk by hand and estimate: if the platform jumps more than 2mm, change the disk. After replacing the disk, make sure to tighten the ring on the platform 8 (closest to the outside of the sand tablet)
6.Standard Configuration With Diamond Disc,Water comes out when power on.
Specification:
Voltage：220V/50Hz±10% 110V/60Hz±10%
Power：500W
Rotational：2800rpm
Dimensions：57*37*42cm
Weight：29Kg
Content:
1x Wet Model Trimmer
1X Power cord
Other accessories
Warranty: One Year! Service: Whole Life!
